Streetlight Options
LED Light Source

Philips Lumileds Luxeon TX
> 135lm/w

Philips Lumiled 3030 2D
> 150lm/w

Philips Lumiled 5050
> 185lm/w

LED Driver
Non-Dimmable

HLG Series LED driver
optimal stability
High performance
Long lifespan

Dimmable

Programmable LED driver
Integrate dimming function
6KV /10KV surge protection.
Provides excellent performance and lifespan.

Ergonomic Design
Suitable for various applications

Body is fixed by two M8 x 16 Stainless Steel screws

Clamshell design for wiring compartment,
Sturdy
Durable

Stainless steel screws
No corrosion issues.

WAGO Internal Connectors
Safe, convenient & fast.

Innovative pluggable connector
Clean & efficient.

 

Efficient inner cavity structure
Thermal convection of LED driver.

 

Aluminium Shell
Designed for heat dissipation

 

Light Distribution

Bri-Tek Technologies’ Street light fits with a wide range of applications, such as motorway, dual carriageway, public and private roads and streets, walkways, and carparks.

There are different options for the light distribution lens for the street light to achieve the best lighting effect across different applications.

Bri-Tek follows the IESNA standard in providing the optional lens width:-

Type I – Walkway / pathway
Type II – 2 lane roads
Type III – Roads wider than 2 lanes
Type IV – Parking lots

Bri-Tek advise our customers on the most suitable lens on a project by project basis.

Type I

The Type I lens of Bri-Tek’s street light has beam angle of 50*160 degrees.

In the IESNA Standard, The Type I distribution is great for lighting walkways, paths and sidewalks. It is generally applicable to where the mounting height is approximately equal to the roadway width.

Type II

The Type II lens of Bri-Tek’s street light has beam angle of 65*155 degrees.

In the IESNA Standard, The Type II distribution is used for wide walkways, on ramps and entrance roadways, as well as other long, narrow lighting. It is generally applicable to where the width of the roadway does not exceed 1.75 times the designed mounting height.

Type III

The Type III lens of Bri-Tek’s street light has beam angle of 80*160 degrees.

In the IESNA Standard, The Type III distribution is designed for roadway lighting, general parking areas and other areas where a larger area of lighting is required. This distribution is intended for luminaires mounted at or near the side of medium width roadways or areas, where the width of the roadway or area does not exceed 2.75 times the mounting height.

Type IV

The Type IV lens of Bri-Tek’s street light has beam angle of 110*110 degrees.

In the IESNA Standard, The Type IV distribution is intended for luminaire mounting at or near centre of roadways, centre islands of parkway, and intersections. It is also meant for large, commercial parking lot lighting as well as areas where sufficient, evenly distributed light is necessary.

Intelligent Street Lighting
Bri-Tek provides a total solution for intelligence street lighting system.

The Bri-Tek intelligent street light system is made up by software, communications controller, terminal controller. The communications controller is installed in the distribution cabinet, the terminal controller is installed in the lighting terminal. It proceeds with communication via GPRS/CDMA/WCDMA wireless network or cable network & monitor center and proceeds with communication via ZIGBEE/PLC.

Communications controller can control each terminal controller via receiving, executing, forwarding PC management software , which can control each lamp’s switching on /off or dimming ,then save electric energy. It can also monitor the lamps’ electric energy to achieve failure lamps function. The communications controller can built-in DO to achieve street light loop control, it can connect with other equipment to collect local illumination, temperature and other information, feedback to PC management software and achieve to monitor the current information.